PDA

View Full Version : anyone out there work in or own a Machine shop?


Dave B.
10-20-2005, 12:05 AM
those of you 03-04 Cobra guys with LT headers,

Remember all the bottom end torque you had with the stock manafold on before you put the long tube headers on? then after the headers were installed that bottom end was gone but then you had higher RPM power

I know a way to have both but need someone with some machining ability or at least an exhaust shop with the ability to bend,weld, manipulate the exhaust,

I even have an "X" pipe ill donate to try what I have in mind,,,,,,

blk04cobra1
10-20-2005, 07:59 AM
our shop is right next to one...if you make all the markings where the bends need to be and your ideas, we could swing it by them and have them do what you want...