View Full Version : K-member

04-20-2006, 09:14 AM
Installing a new engine in my 99 Cobra .. need a link for a new k-member that allows me to drop the engine roughly 1" ..



04-20-2006, 12:57 PM
I think that would be a custom job. The MM k-member doesn't drop the engine.

04-20-2006, 02:39 PM
Thanks ..

Yes Matt from MM emailed me and gave me some info .. I'll most likely have to order their kit and have a friend cut and weld the plates lower .. or see what I can do to raise the master cylinder up about 1/2" to help clear the valve covers.

BOSS330 hadn't said anything about his conversion. And trying to locate information about the 2000 Cobra R "adapter" isn't helping me either :(


04-23-2006, 04:38 AM
I highly recommend that you do NOT cut and reweld the plates. I would try my best to relocate the master cylinder. If you cut the K-member it will ruin the integrity of the piece as a whole. This is just a thought.

Good luck.:)