View Full Version : Data Plate for Shelby GT 500

02-26-2009, 11:11 PM
Check out Robbie Kiser's new plate for his Shelby GT 500 Coupe. The picture is not perfect and my camera now picks up even the fingerprints on the plate. :rolleyes:

BTW, this is not a brushed aluminum plate, it is a "mirror" image plate. If you stand over it and take a picture, your reflection will show in the plate. This plate fits in the embossed area where your yellow factory sticker resides. You can either take the stock sticker out or just adhere the plate over the stock decal. This plate comes with high bond 3M tape so once you put it in there, it's not going to go anywhere. :D

RF Cobra
02-27-2009, 09:32 AM
Good looking plate. :thumbsup:

I'm going to have to get you to make me a new one at some point for mine as something tore the tissue paper it was wrapped in and it now has several long scratches that run the width of the plate. :(

A microfiber towel and a good polarizing filter will help solve your fingerprint and reflection issues.

02-27-2009, 10:09 AM
very nice Tony!! But it will probably look better after installed on the car:D

02-27-2009, 09:26 PM
You can install it next weekend! :thumbsup: