PDA

View Full Version : 381 R Saleen Wing [3 Reply Pics]


ONEJETI
01-21-2003, 04:35 PM
TWO BOLTS HOLDS THE WING ON AND ALOT OF TWO SIDED TAPE...I MADE TWO STUDS UP AND COVERED THE TIPS WITH MASKING TAPE TO KEEP FROM SCRATCHING THE TRUNK AND TO USE THEM AS GUIDES TO GET THE SPOILER IN PLACE..ONCE IT WAS IN PLACE I USED THE STUDS AND NUTS SALEEN SUPPLIED..

ONEJETI
01-21-2003, 04:39 PM
DRILL HOLE ... FEED WIRE THREW BUT DONT TRIM IT...MAKES IS EASY TO FEED WHEN YOU SET SPOILER IN PLACE

ONEJETI
01-21-2003, 04:44 PM
MADE LONG STUDS UP ABOUT 2 1/2 INCHES MADE ALIGNMENT EASY ..TOW SIDED BODY SIDE MOLDING TAPE[[[3 M]]]

ONEJETI
01-21-2003, 04:52 PM
NOTICE THE LITTLE LOGO ON THE TRUNK FROM THE DEALER...ALMOST BACKED OUT OF THE DEAL BECAUSE OF IT..WONT B THERE WHEN THE CAR HITS THE ROAD THIS SPRING,GUESS I SHOULDNT COMPLAIN THEY DID GIVE ME A GOOD DEAL

Venimuz
01-22-2003, 01:06 AM
Have you driven it yet, and if so, noticed any extra end-holding strength from the wing?

ONEJETI
01-22-2003, 12:06 PM
I DROVE IT HOME FROM THE DEALER CHRISTMAS EVE 26 MILES..AND NEVER HAD A CHANCE TO SEE REALLY WHAT THE CAR COULD DO STOCK...I ADDED THE WING AND IN THE PROCESS OF ADDING A MACH 1 CHIN SPOILER MODIFIED AIR BOX,KN FILTER ,CHANGED TO 6 LB PULLY,DIABLO CHIP AND BORLA CAT BACK EXHAUST..ILL B THE WORSE PERSON TO ASK HOW IT COMPARES TO STOCK...BUT I HAD A GTS AND A Z06 SO I KNOW WHAT IT WILL TAKE TO DO BATTLE WITH THEM.SO I AM GOING TO HAVE TO CUT WIEGHT SOME PLACE..SPARE ,TIRE JACK,EXHAUST IS LIGHTER SOME WHAT ,WASHER RES, REAR SEAT DELETE.