PDA

View Full Version : cutout question


lifeat26psi
01-06-2004, 03:30 PM
sup guys' i wanted to put cutouts on my cobra, it has stock headers & h pipe, i wanted to know what size i needed, i want to put it so it dumps out after the headers.

thanks guys.

AF24
01-09-2004, 01:58 PM
I ordered flowtech cutouts for mine(2 1/2inch) because I was going to get the electronic cutouts eventually. I couldn't find anyone that could fit them in there. The flange part of the cutout stuck out too far, and the floorboard was too low(would have only provided about an inch or two ground clearance!) I ended up gettin two pipes with threaded ends(so it doesn't have flange sticking out) and I can open and close them with just unscrewing the ends. Not the greatest way, but the only one I could find. Just thought I'd let you know :)

lifeat26psi
01-12-2004, 12:25 PM
yeah, i ordered the unscrew ones, they are reliable, i just hope they fit. (fingers crossed)