PDA

View Full Version : How to remove the seat belt ding... ding....


03 cobra toy
07-09-2004, 05:05 PM
:) SAFETY BELTS SAVE LIVES!


Read steps 1 - 9 thoroughly before proceeding with the deactivation/activation programming procedure.

Before following the procedure, ensure that the
following conditions are met:




The parking brake is set.

The gearshift is in P (Park) (automatic transmission) or the neutral position (manual transmission).

The ignition switch is in the OFF position.

All vehicle doors are closed.

The driver’s safety belt is unbuckled.

The parklamps/headlamps are in OFF position (If vehicle is equipped with Autolamps, this will not affect the procedure).



The BeltMinder feature can be deactivated/activated
by performing the following procedure:

1. Turn the ignition switch to the RUN (or ON) position. (DO NOT START THE ENGINE.)
2. Wait until the safety belt warning light turns off. (Approximately 1–2 minutes.)



Steps 3–5 must be completed within 60 seconds or the procedure will have to be repeated.


3. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled. This can be done before or during BeltMinder warning activation.
4. Turn on the parklamps/headlamps, turn off the parklamps/headlamps.
5. Buckle then unbuckle the safety belt three times, ending with the safety belt unbuckled.



After step 5 the safety belt warning light will be turned on for three seconds.


6. Within seven seconds of the safety belt warning light turning off, buckle then unbuckle the safety belt.



This will disable BeltMinder if it is currently enabled, or enable BeltMinder if it is currently disabled.


7. Confirmation of disabling BeltMinder is provided by the safety belt warning light flashing four times per second for three seconds.
8. Confirmation of enabling BeltMinder is provided by:


The safety belt warning light flashing four times per second for three seconds.

Followed by three seconds with the safety belt warning light off.

Once again, the safety belt warning light will flash four times per second for three seconds.


9. After receiving confirmation, the deactivation/activation procedure is complete.

Jesse99
07-09-2004, 05:15 PM
Awesome tip.. Will this work on the 99?

03 cobra toy
07-09-2004, 05:17 PM
Awesome tip.. Will this work on the 99?

I think so....

jimmysidecarr
07-09-2004, 05:18 PM
Thanks Dave!
I have been meaning to do that for weeks now!
Now I don't have to dig out the fine print(owners manual)
Printed it on the laser at work------->normal sized print

Jimmy :thumbsup:

Carl G
07-09-2004, 06:07 PM
More great info, where do you find all this material?" :D :thumbsup:

Firme
07-09-2004, 07:45 PM
More great info, where do you find all this material?" :D :thumbsup:


Its in the owners manual :D

Carl G
07-09-2004, 08:45 PM
Its in the owners manual :D
Who's got that much time to read that silly book ;) Anyhow that what your for :D :rotf: :rotf: :) :bounce: