PDA

View Full Version : Roo'


beerkat
08-31-2004, 02:48 PM
http://www.svtcobraclub.com/forums/vbgarage.php?do=thumb&width=144&id=151 (http://www.svtcobraclub.com/forums/vbgarage.php?do=popup&image=http://www.svtcobraclub.com/forums/vbgarage.php?do=getimage&id=151) Here is a picture of my new roll bar.:bounce: I picked it up from Carolina Mustang. Nice place, good people. It is in Cary, NC they carry preformance parts for Mustang and Cobras. They alsohave a classic Mustang section next door but I did not take a look. This is an AutoPower roll bar and it took my brother and me about 4 hours to install. Still have to do the rear seat delete. Getting ready fot the AX and Dragon in October.:rotf:

Hazman
08-31-2004, 06:34 PM
Hey Kim
Looking good there!!! :thumbsup: Now to see what that beast can do on the Mini-Dragon AX and on the real thing!! :eek:

This is the most important mod there is for a vert. :D ;)

SlowSVT
09-01-2004, 04:33 AM
Kim

Are you going to get a cover made for the padding to hide up those zip-ty's? If you do consider using black Cordura with velcro closures.

Russ :baby:

beerkat
09-01-2004, 10:22 AM
That is a padded vinyl cover that is on there. I used the zip ties to fit it around the cross members. I have not had the time to rework it so it fits better. It as a velcro closures. But It is not real heavy padding. I like you idea of using cordura.:thumbsup: If I can not get this one to fit better I might just have to make one.

I wish this rain would go away so I could do the seat delete and work on the cover. I have my shop in the garage so I can not get a car in it.:(

Yes I plan on putting 5 point harnesses in. Not sure if I will get them by the AX or not. I know that I will have them before I run at CMP again:D