PDA

View Full Version : thats not good


BadMoFo
05-10-2005, 11:07 AM
well doing my boost overlay today and got to the remove needle part, used the tool to pry off the needle and then I noticed the copper needle the plastic need attaches to was in there all limp. went ahead put the sticker on and reenstalled the needle to see maybe if that was normal..................................................................................nope. now I have NO boost reading at all. something inside broke, so now I have to try to figure this out. its always something. I was even following directions for once damn it.

WVSNS&
05-10-2005, 03:05 PM
I hate when that happens. Happened to me on an svo. Ended up replacing the whole thing.

InfamousSVT
05-10-2005, 09:44 PM
Same thing happened to me when I put my Hilton Boost Overlay on. I had to play with it a little to finally get a reading, but then decided to go ahead and get an aftermarket gauge on the pillar!

Speed of Sound!:thumbsup: