View Single Post
Old 03-03-2009, 02:17 AM   #4
Z_Drifter_87
Registered User
 
Join Date: Jan 2009
Location: Harlingen, TX
Posts: 28
Quote:
Originally Posted by Philcsag1
you need to bleed all the air out of the system to get it to properly cool

You need to remove the plug in the crossover tube while filling the engine with coolant.

the engine will come upt to 227 degrees then the fan will turn on

the fact that you put a160 thermostate in will not change that.

Phil
Ok, so normal operating temp is around 220? Would you recommend that i go with a higher temp thermostat? Also would i remove the plug in the crossover tube while its on and add water through there or the resovoir??
Z_Drifter_87 is offline   Reply With Quote