View Single Post
Old 08-12-2018, 10:22 PM   #3
illini1972
Registered User
 
Join Date: Aug 2018
Posts: 2
Thanks for the response!

i have check the temp sensor, ohmed the wires to the switch and checked voltage to the switch, they are both correct.
i have replaced the CCRM, had the PCM reflashed, replaced the fan, so almost everything in the cooling system has been checked or changed.
i did notice that when i checked the pigtail on the fan, that when i turned on the AC the voltage came across the low speed wire on the high speed wire, so i am wondering if i might have crossed the high and low wires when i replace the pig tail for the fan.

i was hoping someone might have a picture of a fan pigtail so i can see which wire went where and hopefully make sure mine is right or not

Robert
illini1972 is offline   Reply With Quote