SCMC Message Forum - View Single Post - Post your GT 500 pics here! (And hp numbers, too)

blk04cobra1 · 07-22-2008, 09:23 AM

Rick,

I know it won't void the warranty if you have it installed by the dealer, but for $2k, you could get a lot of aftermarket parts with more power. IMO, I would go with a JLT carbon fiber intake, then a smaller pulley on the blower, with a custom dyno tune. These two easy bolt on's should net you in the low-mid 500 rwhp range and cost less than $2k. Then you could add some suspension parts on top of that. The FRPP shorty headers will bolt to the factory exhaust, but I would save the headers for when your pushing more power.

check this out and they are a sponsor on the board:

http://jlttruecoldair.com/zencart/in...roducts_id=115

07-22-2008, 09:23 AM	#23
blk04cobra1 Registered User Join Date: Nov 2004 Location: Charlotte, NC Posts: 1,374	Rick, I know it won't void the warranty if you have it installed by the dealer, but for $2k, you could get a lot of aftermarket parts with more power. IMO, I would go with a JLT carbon fiber intake, then a smaller pulley on the blower, with a custom dyno tune. These two easy bolt on's should net you in the low-mid 500 rwhp range and cost less than $2k. Then you could add some suspension parts on top of that. The FRPP shorty headers will bolt to the factory exhaust, but I would save the headers for when your pushing more power. check this out and they are a sponsor on the board: http://jlttruecoldair.com/zencart/in...roducts_id=115 __________________ 2004 Cobra HP Twin 67's 785rwhp on 9lbs of boost